Programming: Software Upgrade And Flexing; Part Numbers - Motorola A1200 Service Manual

Level 1 and 2 Service Manual
Table 3. Level 1 and 2 Troubleshooting Chart (Continued)
Symptom
7. Telephone will not recognize or accept
SIM card.
8. Vibrator feature not functioning.
9. No or weak audio when using headset. a) Headset plug not pushed in fully.

Programming: Software Upgrade and Flexing

Part Numbers

6809499A19-O
Probable Cause
a) SIM card defective.
b) Transceiver board defective.
Transceiver board defective.
b) Faulty jack on transceiver board.
Contact your local technical support engineer for information about equipment and
procedures for flashing and flexing.
The following section provides a reference for the parts associated with
A1200 telephones.
December 21, 2005
Verification And Remedy
Check the SIM card contacts for dirt. Clean if
necessary, and check if fault has been cleared.
If the contacts are clean, insert a known good
SIM card into the telephone. Power up the unit
and confirm that the card has been accepted. If
the fault goes away, replace the defective SIM
card. If the SIM card is not at fault, proceed to b.
Replace the transceiver board (refer to 1c).
Verify that the fault has been cleared and
reassemble the phone with the new transceiver
board.
Replace the transceiver board (refer to 1c).
Verify that the fault has been cleared and
reassemble the phone with the new transceiver
board.
Ensure the headset plug is fully seated in the
jack.
Replace the transceiver board with a known
good transceiver board (refer to 1c). Verify that
the fault has been cleared and reassemble the
unit with the new transceiver board.
Part Numbers
46