Changing The Basic Settings; Cleaning Function; Before Cleaning; Setting - Siemens HB43.R SERIES Instruction Manual

Changing the basic settings

This oven has different basic settings. The settings can be
adapted to the user's own needs.
Basic settings
Selection
Time indicator always*
™‚
Duration of signal approx.
™ƒ
after the cooking 10 sec
time or the time set
on the timer has
elapsed
Time until a set- approx.
™„
ting is applied 2 sec
* Default setting

Cleaning function

The cleaning function regenerates the self-cleaning surfaces
inside the oven.
The inside rear and side walls and ceiling of some ovens may
be lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning system makes it possible to
regenerate self-cleaning surfaces that can not properly clean
themselves.

Before cleaning

Remove all pans and unsuitable accessories from inside the
oven.
Cleaning the oven's base and enamelled walls
Before programming the clean function, clean the surfaces
inside the oven that are not self-cleaning. Otherwise, stains will
appear that are impossible to remove.
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.

Setting

Cleaning takes approximately one hour.
Turn the control knob to Hot Air
1.
Turn the temperature knob to
2.
Press the button.
s
3.
The time when the cleaning will be finished is displayed and an
arrow N will appear in front of the
starts within a few seconds. The duration is displayed, and an
arrow is displayed in front of the
N
switches off.
10
‚ Selection ƒ Selection
only with -
the
button
0
approx. approx.
2 min.* 5 min
approx. approx.
5 sec.* 10 sec.
.
2
s .
y symbol. Self-cleaning
symbol. The symbol
x y
No other time function can be programmed.
Press the 0 button for approximately 4 seconds.
1.
The display panel will show the current basic setting for the
„
time, e.g. for the Selection
™‚
Set the basic setting using the buttons
2.
Confirm with the
3.
The display panel shows the following basic setting. Using
the button 0 select the levels and using the buttons
make the setting.
Press the button for approximately 4 seconds.
0
4.
All basic settings have been applied.
The basic settings can be changed again at any time.
The cleaning has finished
A beep will sound. The oven will stop heating. The display
panel will show
‹‹
function control knob to position
To cancel cleaning
Press the button
s
the setting. The oven switches off.
Û
Delaying the end time
The time at which cleaning finishes can be changed. Thus,
for example, the oven can be cleaned at night leaving it free for
use during the day.
Program as described in point 1 to 3. Before cleaning is
finished, delay the end time using the
The oven is set to standby. The time when the cleaning will be
finished is displayed and an arrow
the symbol. When cleaning begins, the time is displayed
y
and an arrow appears in front of the symbol
N
symbol switches off.

After cleaning

Once the inside of the oven has cooled, clean the ash remains
from the self-cleaning surfaces using a damp cloth.
.
‚
@ or
button.
0
: . Press the button twice and turn the
‹‹ 0
Û . The oven switches off.
and turn the function control knob to
or
@ A
will appear in front of
N
A .
@ or A
buttons.
. The
x y