Panasonic KX-TG2680N Operating Instructions Manual page 90

Before Requesting Help
General
Problem
The unit does not work.
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
"Recharge battery" is
displayed on the handset,
" " flashes or the unit
beeps intermittently.
You charged the battery
fully, but "Recharge
battery" is still displayed
and/or "
flash.
90
" continues to
Remedy
•Check the settings (p. 10–14).
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install the battery properly (p. 80).
•Insert the handset in the cradle and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery and insert the
handset in the cradle (p. 80). Try again.
•Programming is not possible while the
unit is in the talk or speakerphone mode,
when viewing the Caller List/directory
list, or while the answering system is in
use.
•Do not pause for over 60 seconds while
programming.
•Move closer to the base unit.
•
, , or
Ö Ñ Ü á
pressed when you picked up the
handset. Press
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install a new battery (p. 80).
may have been
and try again.
(OFF)