Table of Contents
Advertisement
Before Requesting Help
Cordless Telephone
Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the base
unit do not ring.
The handset display is
blank.
The handset display is still
blank after pressing
or
.
Ü
á
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
86
•You are too far from the base unit. Move
closer and try again.
•Insert the handset in the cradle and try
again.
•Plug in the AC adaptor.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Locate the handset and the base unit
away from other electrical appliances
(p. 3).
•Move closer to the base unit.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Press
channel.
•The ringer volume is set to OFF. Set to
HIGH or LOW (p. 18, 19).
•The handset is in the standby mode
(p. 9). Press
the display on.
•Charge the battery fully (p. 11).
,
,
Ö
Ñ
•You cannot store an item in the directory
while the unit is in the talk,
speakerphone or intercom mode, or
while the answering system is in use.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press
(DIGITAL!SP-PHONE)
the beginning after hanging up.
Remedy
(FUNCTION/CH)
,
,
Ö
Ñ
Ü
. Start again from
to select a clearer
or
to turn
á
,
or
Advertisement
Table of Contents
