Error Table Of Status Indicator - Yamaha WXA-50 Owner's Manual

Error table of STATUS indicator

Refer to the table below when the STATUS indicator on the front panel flashes in error indications.
Color
Flashing, and the power turns off immediately after the
power has been turned on
Flashing, and the power does not turn on
Fast flashing
Flashing (every 0.5 second) *
Slow flashing (every 1 second)
Flashing
Slow flashing after turning on the unit
* The NET indicator and (Bluetooth) indicator flash at the same time.
Condition
2 - 8 times
4 - 8 times
Once
Repeat blinking 2 - 7 times and 1
second off until the unit is turned off
Twice
3 times
5 times
Repeated until the unit is turned off
Twice
10 times
Blink
As a safety precaution, the unit has turned itself off.
As a safety precaution, capability to turn on the unit is disabled. Contact your
nearest authorized Yamaha dealer or service center to request repair.
No presets have been registered.
An error occurred during firmware updating. Check the connection of the USB
memory device, or the unit to the network, and then update the firmware again.
An error is occurring with the USB device.
An error is occurring with the network.
An error is occurring with WAC/WPS/CONNECT.
Firmware update failed. Update the firmware using a USB memory device (p.35).
The remote control IDs of the unit and the remote control are not identical, or
reception of the remote control signal is disabled. To specify the remote control
settings, see "CONFIGURING ADVANCED FEATURES" (p.29, p.32).
A new firmware update is available. Update the firmware (p.35).
41
En
Status of the unit