Bluetooth - Yamaha WXA-50 Owner's Manual

Problem
The unit cannot connect to the Internet via a
wireless router (access point).
Bluetooth®
Problem
Cannot make the unit pair with a Bluetooth device.
Cause
The unit and the wireless router (access point) are too far apart or
there is an obstacle between them.
Cause
The Bluetooth device does not support A2DP.
A Bluetooth device that you want to pair with the unit has a password
other than "0000".
The unit and the Bluetooth device are too far apart.
There is a device (such as a microwave or a wireless network device)
that outputs signals in the 2.4 GHz frequency band nearby.
The unit enters standby mode.
The wireless switch on the rear panel is turned off.
The wireless antenna is not attached.
Another Bluetooth device is already connected to the unit.
Private Mode is set to "On". In this case, you can connect only a
Bluetooth device that has been connected before.
Place the unit and the wireless router (access point) closer to each other or move
them to a location where there are no obstacles between them.
Use a Bluetooth device that supports A2DP.
Use a Bluetooth device whose password is "0000".
Move the Bluetooth device closer to the unit.
Move the unit away from those devices.
Turn on the unit and select Bluetooth as the input source, and then perform
pairing with the device.
Set the wireless switch properly to enable the Bluetooth connection (p.7).
Attach the wireless antenna.
Terminate the current Bluetooth connection and then establish a new connection.
Set Private Mode to "Off" and then connect the new Bluetooth device.
40
En
Remedy
Remedy