Table of Contents
Advertisement
SETTINGS (Menu)
MAC filter
Mode
Network Standby
Backup / Recovery
Firmware
Licenses
* After configuring the network settings, it may be necessary to access the unit again or restart the browser.
SETTINGS2
SETTINGS (Menu)
Enhancer
Bass Extension
Monaural Downmix
Sound
Direct
Ultra Low Jitter PLL
Item
Setting values
Off / On
Off / On / Auto
-
-
-
Item
Setting values
Off / On
Off / On
Off / On
Off / On
Level1-3
Default
Enables/disables the MAC address filter function.
Note
When enabling the MAC address filter, be sure to check the MAC
Off
addresses carefully before clicking "APPLY". Configuring the filter
incorrectly may result in the unit becoming inaccessible. If this happens,
the unit must be restored to the default settings (p.36).
Enables/disables the feature allowing the unit to be turned on by
Auto
network devices (Network Standby).
Saves the unit's current settings to a PC or loads them back from a
PC.
Note
▪ The backup does not contain user information (such as user accounts
-
▪ Do not operate the unit during the recovery process (loading the
-
Updates the unit's firmware from the web browser.
-
Displays license information about the software used by the unit.
Default
Enables/disables the Compressed Music Enhancer feature
On
(p.42).
Enables/disables extension of the low-frequency range of the
frequency band of the speakers' playback. When this is "On", you
Off
can enjoy rich bass sounds as if you are using significantly larger
speakers.
Enables/disables a mode that plays back stereo signals as
Off
monaural audio.
Enables/disables Direct playback. When this is enabled, audio is
Off
played back without being passed through the DSP.
Sets the strength of the jitter removal applied to the audio input
being played back, in order to adjust the audio quality.
When the level is set high, the jitter removal is more effective, but
Level2
the sound is likely to cut out.
When the level is set low, the jitter removal is less effective, but the
sound is less likely to cut out.
29
En
Explanation
and passwords) or unit-specific information (such as its IP address).
settings back from a PC), as this may result in the incorrect recovery of
the settings. When the recovery finishes, click "OK" to set the unit to
standby mode.
Explanation
Hide quick links:
Advertisement
Table of Contents
