Using The Grill - Zanussi ZCG62226 User Manual

In case of absence of the electricity you can
ignite the oven burner without an electrical
device.
Oven safety device:
The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.
1. Open the oven door.
2. Hold the flame near the hole in the bottom
of the oven cavity.
3. At the same time push the knob for the
oven functions and turn it counterclockwise
to the maximum gas flow position.
4. When the flame comes on, keep the knob
for the oven functions pushed on the
maximum gas flow position for 15 seconds
or less to let the thermocouple warm up.
Do not keep the knob for the oven
functions pushed for more than 15
seconds. If the oven burner does not
light after 15 seconds, release the
knob for the oven functions, turn it
into off position, open the oven door
and try to light the oven burner again
after minimum 1 minute.
After igniting the oven gas burner
1. Release the knob for the oven functions.
2. Close the oven door.
3. Turn the knob for the oven functions to set
the necessary heat setting.
Control the flame trough the holes in the bottom
of the oven.
Turning off the oven burner
To put out the flame, turn the knob to the off
position .
12

Using the grill

CAUTION!
Always keep the appliance door
closed when the grill operates.
The grill temperature cannot be
adjusted. To get a lower temperature
or slower cooking time, lower the
grill pan away from the flame.
Do not put the meat directly on the
tray or pan.
CAUTION!
Do not put the meat on the highest
shelf level. There is a risk of fire.
CAUTION!
Make sure to turn the knob for the
oven funstions as far as it goes.
Avoid the intermediary position
between Off and Grill. On the
intermediary positions the spark
generator can remain active.
1. Open the oven door.
2. Ignite the grill burner.
• For manual ignition hold a flame near the
grill burner holes. Push and turn the
knob for the grill to the flame position.
Hold the knob pushed down.
• For ignition on the spark generator
button push and hold the spark
generator button. Push and turn the
knob for the grill to the flame position.
Hold the knob pushed. Release the
spark generator button when burner
lights.
3. Hold the knob for the grill pushed for
approximately 15 seconds.
4. Release the oven control knob.
If the grill does not come on or if it
accidentally goes out release the knob for
the oven functions and turn it to the Off
position. Open the oven door. After one
minute, try to light the grill again.
5. Preheat the grill for 5 to 10 minutes.
6. Put the oven shelf with the meat on shelf
position 3.
7. Put a baking tray or roasting pan below, on
shelf position 2, to collect the juices.
If there is temporarily no power supply open the
oven door hold a flame near the grill burner
www.zanussi.com