Auto Trace Setting
This item stores and reproduces manual operation.
Click the [Auto Trace] tab on the [PTZ Controller] screen and configure settings at the [Auto Trace] setting
screen.
Note:
● As Auto Trace performs simple saving of manual operation, the position may be shifted during
playback.
● ADigital FlipB cannot be used during Auto Trace recording. [Auto Flip] (A Page 59)
A
Click the [Auto Trace] tab to display the [Auto Trace]
screen.
B
Click [Record Start].
The camera will start recording of Pan/Tilt and
Zoom operations. (for approximately 30 seconds)
:
Memo
● For details on the manual operation, see
[Operation] (A Page 106).
C
When manual operations are completed, click
[Record Stop].
[State] Display
The current status is displayed.
Standby
: The camera is on standby. [Record
Stop] is invalid.
Recording : The camera is recording. Click [Record
Stop] to finish recording. ACompletedB
will be displayed.
Completed : Recording is completed. After
ACompletedB is displayed for 3
seconds, AStandbyB will be displayed.
Timeout
: 30 seconds has passed since recording
started. (Operation for the 30 seconds
has been recorded.) After ATimeoutB is
displayed for 3 seconds, AStandbyB will
be displayed.
Memory Full : The operation has exceeded the
number of recordable operations.
Further recording cannot be made
even if it is within 30 seconds.
(Operations before the limit are
recorded.) After AMemory FullB is
displayed for 3 seconds, AStandbyB
will be displayed.
113