JVC VN-V686U Instructions Manual page 115

Symptom
Multicast images cannot be
played back
The frame rate of the displayed
image is low
A white zone appears in
viewer
A warning message appears
upon starting up Built-in viewer
Causes and Countermeasures
● Start multicast transmission manually from the
[Streaming] page of VN-V686U.
● In the case of multicast reception at
viewer, check that the multicast address and port
number of
those on the [Streaming] page of VN-V686U.
Make use of a network that supports IGMP v2 for
multicast transmission.
● Multicast may be blocked by the WindowsXP
firewall. When this occurs, perform the following
to allow it to pass through.
Double-click [Windows Firewall] under [Start]-
[Control Panel], click the [Add Port...] button
under the Exception tab, and register the port
number to be allowed through the firewall in the
Port Number field. Enter an arbitrary character
string in the name field.
● Check
Built-in viewer
viewer is in use.
● Frame rate will be constrained when the network
bandwidth is narrow.
Built-in For some computers, a part of the Internet Explorer
graphics may not appear and is left white when the
following setting is performed on the Internet Explorer.
If [Right-click on the Desktop screen]-[Properties]-
[Settings]-[Advanced]-[Advanced]-[DPI setting] is
set to ALarge sizeB or ACustom sizeB, select ANormal
size(96DPI)B to resume normal drawing.
Built-in viewer
ActiveX.
The ActiveX is usually installed when
used for the first time. However, installation may be
rejected depending on the Anti-virus software settings.
In this case, change the settings of the Anti-virus
software before installing
Built-in viewer settings coincide with
settings when a built-in
consists of a software component called
Built-in viewer.
Reference
A Page 70
A Page 96
A Page 101
Built-in
A Page 96
A Page 101
Built-in viewer is
Page
^
^
115