JVC VN-V686U Instructions Manual page 30

Network Settings
IP Address Settings
(contiuned)
Changing the IP address using the Internet Explorer (contiuned)
6
The top page of VN-V686U appears
7
The [Basic] page with the IP address settings appears
A confirmation screen appears. Press the [OK] button. VN-V686U restarts using the new IP address. It takes
about one minute for the camera to reboot.
:
Memo
● Access from this computer may fail when the IP address of VN-V686U is changed. To enable access
to VN-V686U from the same computer, alter the IP address at the computer accordingly.
When the display or configuration of the opened screen appears strange, check the computer
settings using the following procedures.
A Click [Start]-[Control Panel]-[Display] and open the [Display Properties] window
B Click the [Settings] tab in the [Display Properties] window and click the [Advanced] button
C Check that [DPI setting] in the [General] tab has become [Normal size(96DPI)]
D Otherwise, change the setting to [Normal size(96DPI)] and reboot Windows
30
Click on [Network], followed by [Basic] on
the next submenu.
Set the [IP Setting] item to [DHCP Disable].
A
B Enter the values you wish to specify in the
[IP Address], [Subnet Mask] and [Default
Gateway] fields.
Click [OK].
C