Safety Precautions - JVC VN-V686U Instructions Manual

● Before starting an important recording, be
sure to perform a test recording in order to
confirm that a normal recording is possible.
● We do not accept liability for the loss of a
recording in the case of it becoming
impossible to record due to a problem in
the video camera, VTR, hard disk recorder
or video tape.
● The Automatic Tracking function and the
Motion Detection function are simple
functions and cannot be used as a
substitute for a security alarm. JVC shall
not be liable for any inconveniences or
damages caused in the event of error
detection or when these functions cannot
be detected. We shall not be liable for any
inconveniences or damages caused as a
result of operational failure for alarm input/
output.
How to Read this Manual
Symbols used in this manual
Note : States precautions to be taken
during operation.
Memo : States restrictions on the
functions or use of this
equipment. For reference
purposes.
A
: Indicates the page numbers or
items to refer to.
Contents of this manual
● JVC holds the copyright to this manual. Any
part or all of this manual may not be
reproduced without prior consent from the
company.
● Windows is a registered trademark of
Microsoft Corporation in the U.S.
● Product names of other companies
described in this manual are trademarks or
registered trademarks of the respective
companies. Symbols such as
are omitted in this manual.
● Design, specifications and other contents
described in this manual are subject to
change for improvements without prior
notice.

Safety precautions

Mounting to a firm place
As the unit rotates at high speed, mount it on a
firm place with sufficient strength to support the
vibration and weight of the unit (approx. 5.5 kg).
If the strength is weak, the vibration will cause
fuzzy images on the monitor screen. In the worst
scenario, the camera may even fall off and hit
somebody, resulting in serious accidents.
Mounting the camera correctly with
the designated clamping brackets
Always use the designated clamping brackets.
Be sure to connect the fall prevention wire and
tighten the fixing screws or nuts securely.
Using the correct power and voltage
The rated power of this product is AC 24 V, 50
Hz/60 Hz. Supplying a power beyond the rated
value may result in failures and in the worst
scenario, smoking and fire.
This unit is able to divert lightening conduction to
itself and the connecting cables to a certain
extent but this is not 100 % guaranteed. For
installation locations that are likely to suffer
lightening strikes, be sure to take appropriate
measures such as adding arrestor to the
connecting cables.
Consult your dealer as special technique is
required when installing this product. Ensure that
the fixing screws or nuts are tightened securely,
otherwise, the unit may fall off.
Inspect the unit regularly.
Screws may be loosened due to vibration or
deterioration of the mounting section. Perform
regular inspections for loosened screws and
check whether there is any danger of the unit
falling off.
, and
Do not hang on this product, shake it, or hand
objects over it. Applying an excessive load may
cause the product to fall off and result in
accidents.
Do not modify this product. It may result in
accidents.
7