Siemens HB 76P.70 S Instruction Manual page 62

Problem
OFF appears in the temperature
display.
The lift position cannot be
stored.
Fault message in the clock
display
E005 or E305
E010, E014, E119, E120, E310,
E314 or E701
E011
E101 or E104
E115
E702, E704, E705 or E706
E703
E711
62
Possible cause
The automatic time limiter
was activated.
The oven was not closed
correctly.
You can clear any fault message with the j clock
button. This resets the oven to its basic settings. You
must reset the time.
If a fault message cannot be cleared or occurs
repeatedly, call the after sales service.
Possible cause
Communication error
between the electronics
modules.
Data error in the
electronics module.
An operating button has
been pressed for too long.
The temperature sensor is
overloaded.
The oven temperature is
too high.
Data error in the lift
electronics.
The floor contact does not
work.
A lift button has been
pressed for too long.
A lift button is stuck.
The front glass panel is
not seated correctly.
Remedy/notes
Switch off the oven with the @
main switch.
Close the oven fully again and then
reopen it.
Remedy/notes
Press the j clock button.
Reset the clock.
Press the j clock button.
Reset the clock.
Press all operating buttons
individually and check whether
they are stuck.
Press the j clock button.
Reset the clock.
Let the oven cool down before
using it again.
Press the j clock button.
Reset the clock.
Press the j clock button.
Reset the clock.
Press the j clock button.
Reset the clock.
Press all lift buttons individually
and check whether they are stuck.
Move the front glass panel slightly
until the lift buttons are no longer
stuck.