Table of Contents
Advertisement
6 Using the System
6.3.5 Making pulse meter settings
If you have connected pulse meters, use this screen to set the target distribution groups and the
amount of electricity or gas per pulse.
Procedure
Select 5. Initial settings in the main menu, and 4. Pulse meter setting in the sub menu.
1 Select the pulse meter connection destination.
2 You can change the type of pulse meter (power meter or gas meter). The above indicates the
factory default state. When you touch the Meter type area, the Meter type window appears so
that you can select the type of pulse meter to use.
3 Touch a distribution group number. A numeric keypad appears for the distribution group. Use
the keyboard to enter the distribution group number.
* The distribution group number range is from 1 to 8.
* The distribution group buttons are disabled when you have chosen not to perform distribution rate
calculations (see
4 Touch the pulse unit amount column and enter the amount of electricity (kWh) or gas (m
pulse.
5 If the product type is HOT Multi, select the unit for fuel metering.
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
5
1
5
1
).
Main
Sub
1.Date/Distrib.
2.CNTR/Unit/Ten. No.
3.Ten. name/Distrib. Gr.
4.Pulse meter setting
5.Clear accum. data
28
5
4
5
4
Main
Sub
3
) per
Hide quick links:
Advertisement
Table of Contents
