Table of Contents
Advertisement
Summary of Programming Features
This unit has base unit programming and handset programming modes.
Be sure that the power is ON (p. 16), you are in the stand-by mode, and the
handset is near the base unit. See the noted pages for details.
The base unit program mode has the following functions.
To set the Dialling Mode, see page 17.
To set the Pause Timing, see page 29.
To set the FLASH/EARTH Mode, see page 31.
To change the Base Unit Password, see page 35.
To set the Call Restriction, see page 38.
To clear the Settings in Base Unit Memory, see page 46.
To cancel a Handset, see page 50.
To select "Cyclic", see page 54.
To select the Handset(s), see page 55.
To select the First Handset, see page 56.
To select All Handsets, see page 57.
The handset program mode has the following functions.
To clear Redial Memory, see page 22.
To set the Receiver Volume, see page 24.
To set the Handset Ringer Volume, see page 25.
To change the Handset Password, see page 34.
To set the Call Prohibition, see page 36.
To set the Direct Call Mode, see page 40.
To select the Talk Mode Display, see page 42.
To set the Handset Ringer Pattern, see page 43.
To set the Key Tones, see page 43.
To set the Range Warning Alarm, see page 44.
To set the Battery Low Alarm, see page 44.
To clear the Settings in Handset Memory, see page 45.
To register a Handset in the Base Unit, see page 48.
To cancel a Base Unit, see page 51.
To select the Stand-by Mode Display, see page 52.
To set the Call Waiting Tone, see page 61.
To set the Base Unit Access, see page 69.
Helpful hints for programming
To cancel during programming, press
beginning.
If 5 beeps sound during programming, a wrong key was pressed.
Enter the correct number again.
To return to the previous step during programming halfway, press
(Cancel).
(Program), then start from the
33
Advertisement
Table of Contents
