Selecting the Dialling Mode
You can program the dialling mode by using the handset near the base unit.
If you have touch tone service, set to TONE. If rotary or pulse service is used,
set to PULSE. The factory preset is 1 (TONE).
Be sure that the power is ON (p. 16) and you are in the stand-by mode.
1
Press
(Program), then
"
" and "
2
Press
.
3
3
Enter the base unit password.
The factory preset of the base unit password is
0000. If you have changed the base unit
password (p. 35), enter the new password.
4
Press
.
1
The current setting is displayed.
5
To select PULSE, press
OR
To select TONE, press
6
When finished, press
A confirmation tone sounds.
"
" and "
To cancel during programming, press
INT
" are displayed.
2
.
.
1
(Program).
" go out.
(Intercom).
3 - - - -
3
3 I I
Ex. PULSE is selected.
3 I 2
(Program), then start from step 1.
17