Table of Contents
Advertisement
Programming
R This feature cannot be set during a
monitoring call.
1
Press M
N on the handset being
monitored.
2
MbN: "Sensitivity Level" a MOKN
3
MbN: Select the desired setting. a MOKN
a M
N
Answering the baby monitor
n When monitoring with a handset:
Press M
N to answer calls.
If you want to respond from the monitoring
handset, press M N.
R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 29).
Note:
R If you receive an outside call when
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press M
n When monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R 2 minutes after the monitored handset
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.
Other programming
Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customise the name
of each handset (Bob, Kitchen, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 46).
46
PRL250EX1(en)1006_ver011.pdf
N, then press M
N.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
46
1
M
N (right soft key) #104
2
Enter the desired name (10 characters
max.).
3
MOKN a M
N
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
M
N (right soft key) #105
2
MbN: Select the desired setting. a MOKN
a M
N
Call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
M
N (right soft key) #256
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, see page 59.
3
Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R " " is displayed next to the selected
handset numbers.
R To cancel a selected handset, press
the same dial key again. " "
disappears.
4
MOKN
5
Select a memory location by pressing 1
to 6. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M
N
2014/10/06
15:04:35
Advertisement
Table of Contents
