Table of Contents
Advertisement
Link to Mobile
Link to mobile feature
You can connect your base unit and mobile
phone using Bluetooth wireless technology, so
that you can make or answer mobile calls
using your phone system.
This allows you to:
– use the unit to talk on mobile calls even if
some areas of your home have poor mobile
reception, simply by placing your mobile
phone in an area with good reception.
– talk on mobile calls even if your mobile
phone is in your pocket or bag.
– enjoy cordless mobile calls even if your
mobile phone plugged in and charging.
Important:
R You may pair a maximum of 2 mobile
phones. However, the base unit allows only
one Bluetooth to be active at a time.
R The unit may not function properly with your
Bluetooth device's phone app depending
on your Bluetooth device model, the
devices connected to your Bluetooth
device, and the apps installed on your
Bluetooth device.
R Your mobile phone must support the Hands
Free Profile (HFP) specification.
Pairing a mobile phone
Important:
R Before pairing a Bluetooth enabled mobile
phone to the base unit, make sure that no
other Bluetooth device is connected to your
mobile phone.
1
Handset:
For mobile 1: M
#6241
For mobile 2: M
#6242
R After the corresponding indicator (
) on the base unit starts flashing, the
rest of the procedure must be
completed within 5 minutes.
20
PRL250EX1(en)1006_ver011.pdf
N (right soft key)
N (right soft key)
/
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
20
2
Your mobile phone:
While the corresponding indicator (
is flashing, follow the instructions of your
mobile phone to enter the pairing mode.
R Depending on your mobile phone, it
may ask you to enter the Bluetooth
PIN (default: "0000"). If your mobile
phone shows PassKey confirmation on
its display, follow the directions to
proceed.
3
Handset:
Wait until a long beep sounds.
R It may take more than 10 seconds to
complete pairing.
R When the corresponding indicator (
) lights up, the mobile phone is
connected to the base unit. You are
ready to make mobile calls.
4
M
N
Note:
R Make sure that your mobile phone is set to
connect to this product automatically. Refer
to your mobile phone's operating
instructions.
R Make sure you cancel your mobile phone's
current pairing if you want to pair it to the
other line (page 20).
R The default setting for the SMS alert feature
is "On", so when you pair your mobile
phone to the base unit, this feature may be
activated (page 53). (This depends on the
version and type of mobile phone you are
using.)
Unpairing a mobile phone
You can cancel the pairing of a mobile phone
that is stored in the base unit.
1
For mobile 1: M
N (right soft key)
#6111
For mobile 2: M
N (right soft key)
#6112
2
MbN: "Yes" a MOKN
R When the mobile phone is unpaired,
the indicator (
/
3
M
N
2014/10/06
15:04:34
/
)
/
) is turned off.
Advertisement
Table of Contents
