Table of Contents
Advertisement
Getting Started
n When the
indicator flashes slowly in
standby mode, you can:
– View the caller list when there are
missed calls. (page 50)
To activate this feature, their Smart
Function Key must be "On". (page 18)
Using the Smart Function Key (
key)
When the
indicator flashes rapidly/slowly,
press M
N.
R The above features can be activated
depending the situation.
R If you answer a call using the Smart
Function Key, the speakerphone is
activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk without lifting up the
handset. If you want to perform further
operations, lift up the handset.
Note:
R While key lock is on (page 29), incoming
calls can be answered, but the following
feature is disabled even when the
indicator flashes slowly.
– View the caller list when there are
missed calls. (page 50)
Setting the Smart Function Key
The Smart Function Key for the following
feature must be "On".
– "Missed Call" (Default: Off)
The settings can be set for each handset.
1
M
N (right soft key) #278
2
M N
R " " is displayed next to the selected
features.
R To cancel a selected feature, press
M N again. " " disappears.
3
MOKN a M
N
Note:
R If the
indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.
18
PRL250EX1(en)1006_ver011.pdf
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
18
Screen saver mode
The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing M
N when on a call.
– pressing M
N at all other times.
Eco mode setting
If only one handset is registered, and that
handset is on the base unit, the base unit
automatically reduces the transmission power
by up to 99.9 %. When the handset is not on
the base unit, or if multiple handsets are
registered, you can select the desired eco
mode setting by pressing MR/ECON.
The following settings are available for eco
mode.
– "Eco": Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
displayed on the handset display instead of
.
– "Eco Off" (default setting): Turns off eco
mode.
When this setting is selected,
displayed in the handset display.
Note:
R When there is another cordless phone in
use nearby, the base unit transmission
power may not be reduced.
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to "On"
(page 48):
– Eco mode is disabled.
– "Eco Mode" is not displayed in the
display menu (page 39).
2014/10/06
15:04:33
is
is not
Advertisement
Table of Contents
