Install The Access Panel; Remove The Air Baffle - HP Apollo 4200 Gen9 User Manual

Slide the access panel toward the rear of the server, then lift it from the server.
4.
Turn the access panel over to locate the HPE Apollo 4200 Gen9 Server hood label. This label provides
convenient access to component identification, LED status indicators, and system maintenance switch
settings information.

Install the access panel

Place the access panel on top of the chassis, and then insert the tabs into the corresponding slots on
1.
the chassis.
Use a screwdriver to tighten the access panel screws.
2.

Remove the air baffle

To remove the component:
Power down the server (on page 19).
1.
Remove the server from the rack (on page 28).
2.
Operations 30