HP Apollo 4200 Gen9 User Manual page 86

If you are installing the P440 controller for a two-bay SFF hot-plug rear drive cage that is connected
7.
to the front drive cage 2 backplane, disconnect the preinstalled Mini-SAS x4 cable from the two-bay
SFF rear drive backplane.
If you are installing the P440 controller for a two-bay SFF hot-plug rear drive cage that is connected
8.
to the system board, disconnect the multiconnector drive signal cable:
Open the cable management holder (on page 32).
a.
Disconnect the multiconnector drive signal cable from the rear drive backplane and from the
b.
system board.
Close the cable management holder (on page 34).
c.
Hardware options installation 86