Usb Port; I/O Port; Usb Connector; O Connector - Advantech SmartMotion ST355 User Manual

5.8.8 USB Port

Panel socket USB-A.
Pin Signal mark
1 +5 V
2 USB data -
3 USB data +
4 GND

5.8.9 I/O Port

Panel socket 6-pin.
Pin
1
2
3
4
5
6
I/O user Interface is designed for processing of binary input and control (setting) binary
output. Binary output is open in the default configuration. Isolation strength is 1.5 kV. The pins
are isolated from each other with the same strength.
The input circuits are bipolar and allow connection as needed with common plus or minus
(according to connection of an external voltage).
Description
Positive pole of 5 V DC supply voltage, 0.5 A
USB data signal – negative pole
USB data signal – positive pole
Negative pole of DC supply voltage
Table 14: Connection of USB connector
Figure 22: USB connector
Signal mark Description
IN0 Binary input 0
IN0 Binary input 0
IN1 Binary input 1
IN1 Binary input 1
OUT Binary output
OUT Binary output
Table 15: Connection of I/O port
Figure 23: I/O connector
22
5. ROUTER DESIGN
Data flow direction
Input/Output
Input/Output