Power Connector Pwr; Power Connector; Connection Of Power Supply; Connection Of Power Connector - Advantech SmartMotion ST355 User Manual

5.8.2 Power connector PWR

Panel socket 2-pin.
Pin number Signal mark
1 GND(-)
2 VCC(+)
Power supply for the router must be between +10 V to +60 V DC supply. Protection against
reversed polarity without signaling is built into the router.
The router can be put into low power mode using a special command. Then it can be
awakened for example by an activity on binary input or using an internal timer.
Circuit example:
Note for PoE: See Chapter
impact the power supply usage. The power supply for PoE PSE router has to meet the
specific requirements.
Description
Negative pole of DC supply voltage
Positive pole of DC supply voltage (+10 to +60 V DC)
Table 10: Connection of power connector
Figure 13: Power connector
Figure 14: Connection of power supply
5.8.7 for information on how PoE versions of the router
16
5. ROUTER DESIGN