Sony DCR-PC100 Service Manual page 194

DCR-PC100/PC100E
: Changed portion.
Page
3. Battery End Check (VC-227 board)
Adjusting method:
1) Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.0 ± 0.1Vdc.
2) Turn off the power supply.
3) Turn on the HOLD switch of the adjustment remote
5-44
commander.
4) Turn on the power supply.
5) Load a cassette, and set to the camera recording mode.
6) Decrease the output voltage of the regulated power supply so
that the digital voltmeter display is 5.50 ± 0.01Vdc.
7) Record the camera signal for a minute.
8) Playback the recorded section and check that the playback
picture and sound are normal.
9-974-191-81
Changed contents
Sony Corporation
Personal VIDEO Products Company
— 4 —
Printed in Japan ©2000.2
Published by Safety & Service Engineering Dept.
2000B1638-1