System Config - Panasonic BT-3DL2550E Operating Instructions Manual

Main Menu
(continued)

SYSTEM CONFIG

Sub menu Settings
B.LIGHT/CONT.
BACKLIGHT
CONTRAST
BACKLIGHT
0 - 50 - 60
MENU
CENTER
POSITION
LB
RB
RT
LT
STATUS
OFF
DISPLAY
3SEC OFF *
CONTINUE
SETUP LOAD
USER5
USER4
USER3
USER2
USER1
FACTORY
SETUP SAVE
USER5
USER4
USER3
USER2
USER1
POWER ON
USER5
SETUP
USER4
USER3
USER2
USER1
FACTORY
LAST
POWER SAVE
OFF
MODE
ON
CALIBRATION
*1 When the monitor is shipped, settings for "USER1" - "USER5" are identical to "FACTORY."
*2 "H SHIFT" ( page 24), "H POSITION", "V POSITION", "PHASE" and "CLOCK" (
or loaded.
*3 So that there is no confusion with 2D mode when working in 3D mode, STATUS DISPLAY will display
information as per the "CONTINUE" setting even if "3SEC OFF" is selected.
32
Description
Selects function to be assigned to BACKLIGHT/CONT. in the picture/
volume adjusting menu.
<BACKLIGHT>
<CONTRAST>
Adjusts the backlight when the B.LIGHT/CONT. submenu is set to
CONTRAST.
Positions the on-screen menu.
<CENTER>
<LB>
<RB>
<RT>
<LT>
Sets display state for input signal status (on-screen menu).
3
<OFF>
<3SEC OFF>
<CONTINUE>
*1*2
Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
*1*2
After loading user data, the screen displays the signal selected before
*1*2
user data was loaded.
*1*2
*1*2
*2
Up to 5 sets of user data can be saved (
*2
They save menu settings and adjustments made in the picture/volume
*2
adjusting menu (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT)
*2
except "SETUP SAVE/SETUP LOAD."
*2
Selects the settings used when the power is turned on.
<LAST>
<FACTORY> Starts up using the factory defaults.
<USER1 - 5> Starts up using USER registered settings.
Sets the power save mode
<OFF> Does not activate the POWER SAVE mode.
<ON> The backlight dims when no signal (NO SIGNAL) is input for 60
seconds or longer. Signal input or menu operation will return the
backlight to its normal brightness.
Connect a CA-210 color analyzer and use this submenu to make a
calibration. It also returns calibration data to factory defaults. (
34)
Underlined values indicate factory defaults.
Adjusts the BACKLIGHT.
Adjusts the CONTRAST.
Center of the screen
Left Bottom
Right Bottom
Right Top
Left Top
Not displayed.
Displayed for 3 seconds after a status change.
Displayed at all times
Starts in the mode used when the power was last turned
off.
page 22).
page 33,
page 41) cannot be saved