System Config - Panasonic BT-LH1710 - Professional - LCD Production Monitor Operating Instructions Manual

Main Menu
(continued)

SYSTEM CONFIG

Sub menu Settings
CONT./BACK.
BACKLIGHT
CONTRAST
BACKLIGHT
0 - 60
SUB WINDOW
FULL
PART
MENU
CENTER
POSITION LB
RB
RT
LT
STATUS
CONTINUE
DISPLAY 3SEC OFF
OFF
SETUP LOAD
USER5
USER4
USER3
USER2
USER1
FACTORY
SETUP SAVE
USER5
USER4
USER3
USER2
USER1
POWER ON
USER5
SETUP
USER4
USER3
USER2
USER1
FACTORY
LAST
COLOR SPACE
SMPTE-C
EBU
ITU-709
POWER SAVE
OFF
MODE
ON
BLACK DATA
OFF
*6
ON
INSERTION
*1 When the monitor is shipped, settings for "USER1" - "USER5" are identical to "FACTORY."
*2 "H-POSITION", "V-POSITION", "PHASE" and "CLOCK" (
*3 When double speed is applied, image lag is reduced by inserting a black signal. However, luminance is lowered
compared to standard speed, and some images may generate flicker. If flicker becomes too noticeable, return to
standard speed (60 Hz/50 Hz).
*4 ITU-709 is an ITU-R BT.709 standard.
*5 Factory preset settings are The U.S.A. and Canada: SMPTE-C, Others: EBU.
*6 This feature can be displayed and set only on the BT-LH1760.
22
Description
Selects function to be assigned to [CONTRAST/BACKLIGHT] (front panel
knob).
<BACKLIGHT> Adjusts the BACKLIGHT.
<CONTRAST> Adjusts the CONTRAST.
Adjusts LCD backlight brightness. Adjust as required by ambient
conditions.
Selects sub-window type.
<FULL> Reduces the entire images for both input signals and places them
side by side.
<PART> Cuts out the center of the images for both input signals and places
them side by side (the images are shown at their original size).
Positions the on-screen menu.
<CENTER> Center of the screen
<LB> Left Bottom
<RT> Right Top
Sets display state for input signal status (on-screen menu).
<CONTINUE> Displayed at all times
<3SEC OFF> Displayed for 3 seconds after a status change.
<OFF> Not displayed.
*1*2
Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
*1*2
After loading user data, the screen displays the signal selected before
*1*2
user data was loaded.
*1*2
*1*2
*2
Up to 5 sets of user data can be saved (
*2
They save menu settings and adjustments made with the picture adjusting
*2
knob (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT) except
*2
"SETUP SAVE/SETUP LOAD."
*2
Selects the settings used when the power is turned on.
<LAST> Starts in the mode used when the power was last turned off.
<FACTORY> Starts up using the factory defaults.
<USER1 - 5> Starts up using USER registered settings.
*5
Sets the studio standard color shade.
*5
*4
Sets the power save mode
<ON> The backlight dims when no signal (NO SIGNAL) is input for 60
seconds or longer. Signal input or menu operation will return the
backlight to its normal brightness.
Doubles the speed of the LCD panel.
<ON> Double speed (120 Hz/100 Hz)
<OFF> Standard speed (60 Hz/50 Hz)
Underlined values indicate factory defaults.
<RB> Right Bottom
<LT> Left Top
page 16).
*3
page 31) cannot be saved or loaded.