Care And Cleaning Of The Monitor; Care And Storage Of 3D Polarized Eyewear; Error Display; Before Calling For Support - Panasonic BT-3DL2550E Operating Instructions Manual

Care and cleaning of the monitor

• Clean the cabinet and protection panel by gently wiping it with a soft cloth.
To remove stubborn soiling, use a cloth dampened in a weak neutral detergent solution and thoroughly wrung out.
Then wipe with a dry cloth. Any moisture entering the monitor could damage it.
• Do not use benzene, thinner and similar solvents for cleaning.
They could discolor the surface and cause the paint to peel.
• Do not directly expose the monitor to spray cleaning.
Any moisture entering the monitor could damage it.

Care and storage of 3D Polarized Eyewear

• Use a soft dry cloth intended for use on eye-glasses when cleaning this product. Remove lint from the cloth before
use as it may damage the product. Do not use benzene, thinner or similar solvents for cleaning as they could
discolor the surface and cause the paint to peel.
• Do not apply water or other liquids to the 3D Polarized Eyewear when cleaning.
• Avoid storing 3D Polarized Eyewear in places with a high temperature or high humidity.
• Contact your dealer if additional 3D Polarized Eyewear is required.

Error Display

When an error has occurred for some reason, the tally lamp notifies the error.
Error display
Inverter error
The tally lamp
flashes red at
1-second intervals.

Before calling for support

When a fault is suspected (Troubleshooting)
If unresolved issues remain after referring to the points below, please consult the store from which the product was
purchased.
Symptom
Image is not 3D
The 3D video looks strange
58
Symptom
If a malfunction occurs in the inverter that
controls backlight brightness, the
backlight goes off and the screen turns
black.
• Is the monitor switched to 3D image mode?
Even in 3D mode, there is a non-stereoscopic mode.
• Persons with a large difference in visual acuity between their left and
right eyes may have difficulty seeing 3D images, or may not be able to
see them at all. Use this monitor after taking the appropriate vision
correction measures.
• Is the 3D image horizontally inverted?
Ensure that the left eye image signal and the right eye image signal are
input correctly when in SIMUL mode.
Remedy
Turn off the power and then turn it back
on. If the problem still persists, consult
your dealer.
Remedy