Input Select - Panasonic BT-3DL2550E Operating Instructions Manual

Main Menu
(continued)

INPUT SELECT

Sub menu Settings
OFF
VIDEO
2D ONLY
ON
AUTO
FORMAT
NTSC
2D ONLY
PAL
75
NTSC SETUP
00
2D ONLY
*3
OFF
SDI1
ON
*3
OFF
SDI2
ON
OFF
YP P /RGB
B R
ON
2D ONLY
YP
MODE
2D ONLY B
RGB-VIDEO
RGB-COMP.
COMPONENT
SMPTE
B75
LEVEL
2D ONLY
B00
INT
SELECT SYNC
EXT
2D ONLY
COMP.
2D ONLY
*3
OFF
DVI-D
ON
MODE
DVI-VIDEO
DVI-COMP.
*1 All five input lines (VIDEO, SDI1, SDI2, YP
inputs ends when the fourth input line is turned off since it will not be possible to turn off the 5th input line also.
*2 "AUTO" is the factory default, but select a specific format when there is risk that the input signal may be
contaminated by outside noise.
*3 When 3D mode is set to SIMUL, the SDI1 and SDI2 lines are selected regardless of the OFF/ON setting.
40
Description
Turns VIDEO line to the INPUT button on/off.
Selects the video input format.
<AUTO> Automatically selects NTSC or PAL.
<NTSC> NTSC
Selects NTSC setup level.
<75>
<00>
Turns SDI1 line to the INPUT button on/off.
Turns SDI2 line to the INPUT button on/off.
Turns YP
P Selects YP
R
<YP
<RGB-VIDEO>
<RGB-COMP.>
Selects YP
<SMPTE>
<B75>
<B00>
Selects the sync signal when using YP
<INT>
<EXT>
Performs analog PC settings. ("COMP."
Turns DVI-D line to the INPUT button on/off.
Selects DVI-D input mode.
<DVI-VIDEO> Selects the RGB signal input of RGB video.
<DVI-COMP.> Selects PC input.
P
B
Select this function when using 7.5% setup signals.
(Adjusts the interior of the monitor to the 7.5% setup
level to suit the black level)
Select this when there is no setup signal.
P /RGB line to the INPUT button on/off.
B R
P (component) or RGB input mode.
B R
P > Selects the YP
B R
Selects the video RGB signal.
Selects the PC RGB signal.
P (component) signal input level.
B R
Signal level complies with SMPTE and P
0.7 V [p-p] at 100% chroma.
Select this when connecting a Betacam or similar
device with a setup function. (Adjusts the interior of the
monitor to the 7.5% setup level to suit the black level)
Select this when connecting a Betacam or similar
device without a setup function.
Select when the synchronizing signal is superimposed
on the G or Y signal.
Select to synchronize with an external synchronizing
signal.
/RGB, DVI-D) cannot be turned off. An attempt to turn off all
R
Underlined values indicate factory defaults.
*1
*2
<PAL> PAL
*1
*1
*1
P signal.
B R
P and RGB-VIDEO input.
B R
page 41)
*1
and P are
B R