Table of Contents
Advertisement
Main Menu
(continued)
SYSTEM CONFIG
Sub menu
Settings
B.LIGHT/CONT.
BACKLIGHT
CONTRAST
BACKLIGHT
0 - 50
MENU
CENTER
POSITION
LB
RB
RT
LT
STATUS
OFF
DISPLAY
3SEC OFF
CONTINUE
SETUP LOAD
USER5
USER4
USER3
USER2
USER1
FACTORY
SETUP SAVE
USER5
USER4
USER3
USER2
USER1
POWER ON
USER5
SETUP
USER4
USER3
USER2
USER1
FACTORY
LAST
POWER SAVE
OFF
MODE
ON
CALIBRATION
*1 When the monitor is shipped, settings for "USER1" - "USER5" are identical to "FACTORY."
*2 "H POSITION", "V POSITION", "PHASE" and "CLOCK" (
Description
Selects function to be assigned to BACKLIGHT/CONT. in the picture/
volume adjusting menu.
<BACKLIGHT> Adjusts the BACKLIGHT.
<CONTRAST> Adjusts the CONTRAST.
Adjusts the backlight when the B.LIGHT/CONT. submenu is set to
CONTRAST.
Positions the on-screen menu.
<CENTER> Center of the screen
<LB> Left Bottom
<RT> Right Top
Sets display state for input signal status (on-screen menu).
<OFF> Not displayed.
<3SEC OFF> Displayed for 3 seconds after a status change.
<CONTINUE> Displayed at all times
*1*2
Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
*1*2
After loading user data, the screen displays the signal selected before
*1*2
user data was loaded.
*1*2
*1*2
*2
Up to 5 sets of user data can be saved (
*2
They save menu settings and adjustments made in the picture/volume
*2
adjusting menu (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT)
*2
except "SETUP SAVE/SETUP LOAD."
*2
Selects the settings used when the power is turned on.
<LAST> Starts in the mode used when the power was last turned off.
<FACTORY> Starts up using the factory defaults.
<USER1 - 5> Starts up using USER registered settings.
Sets the power save mode
<OFF> Does not activate the POWER SAVE mode.
<ON> The backlight dims when no signal (NO SIGNAL) is input for 60
seconds or longer. Signal input or menu operation will return the
backlight to its normal brightness.
Connect a CA-210 color analyzer and use this submenu to make a
calibration. It also returns calibration data to factory defaults. (
31)
Underlined values indicate factory defaults.
<RB> Right Bottom
<LT> Left Top
page 20).
page 37) cannot be saved or loaded.
page 30,
29
Advertisement
Table of Contents
