Initial Instructions - Migatronic PILOT 2000 Instruction Manual

GENERALLY
Digital display
The control panel is equipped with a tripartite LED
display showing the welding current. During standby
the pre-set welding current is displayed, while the
mean current is shown during welding.
Overheating error/
over voltage - under voltage error
Cause: An inverter module is overheated due to
incorrect use or errors in the inverter
module, or the input voltage is out of
permissible range 195-265 V or 340-460
V.
Reaction: The welding process is interrupted. The
error is indicated by the yellow LED with
the pictogram: Thermometer and electric
plug.
Action: If the error is not caused by incorrect
use, call for service.
Welding voltage
For safety reasons the welding voltage LED
lights if the electrode or the torch is under voltage.
Function switch
In TIG mode this switch is used to select
how the function of the trigger on the TIG
torch:

INITIAL INSTRUCTIONS

trigger is released, after which the adjustable slope-
down is activated. By re-triggering during slope--
down the machine will revert to ordinary welding.
Otherwise slope-down will continue in the pre-set
time after which the machine will switch to post-flow.
trigger pressed down. The next press on the trigger
activates the adjustable slopedown. If the trigger is
released before the slope-down is finished, welding
is interrupted.
In the HF-position the HF-generator is activated.
Furthermore TIG or MMA welding can be selected
by means of this switch.
(DC).
this button. The current is adjustable from 5 A to the
maximum current of the machine.
12
Two-stroke:
Welding is started by pressing down the
torch trigger. Welding will continue until the
Four-stroke:
By the first press on the trigger welding will
start and it is not necessary to keep the
AC/DC switch
Used for switch between alternating current
welding (AC) and direct current welding
Welding current
Welding current is adjusted by means of