Onboard Indicators; 5-10 Serial Ata Ports - Supermicro 6038R-DE2CR16L User Manual

S S S
UPER TORAGE YSTEM 6038R-DE2CR16L User's Manual
BMC Enable
Close pins 1/2 of jumper JPB1 to enable
the ASpeed AST 2400 BMC (Baseboard
Management Controller) to provide IPMI
2.0/KVM support on the motherboard.
Please install an SMCI-proprietary cable
(CBL-218L) on the connector JKVM1 on
the I/O backplane for KVM support. See
the table on the right for jumper settings.
5-9

Onboard Indicators

LAN LEDs
The Ethernet ports (located on the I/O
backplane) have two LEDs. On each
port: the orange LED flashes to indicate
activity while the other LED may be
green, amber or off to indicate the speed
of the connection. Please note that LAN1
also functions as an IPMI LAN. See the
table on the right for the functions as-
sociated with the connection speed LED.
BMC Heartbeat LED
A BMC Heartbeat LED is located at
LEDH, the upper LED on I/O back panel.
When LEDH is blinking, the BMC is
functioning normally. See the table at
right for more information.
(PCH) HDD LED
The (PCH) HDD LED is located at HDD
LED1 on the motherboard. When this
LED is blinking, HDD supported by the
Intel PCH is active. See the table at right
for more information.
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Disabled
LAN1/2 LED
(Connection Speed Indicator)
LED Color Definition
Off No Connection, or 10 Mb/s
Amber 1 Gb/s
Green 10 Gb/s
BMC Heartbeat/System Heartbeat
LED Status
State Definition
Green Blinking BMC Normal
(PCH) HDD Activity LED
LED Status
State Definition
Green: Blinking PCH HDD:
Active
5-16
System Heartbeat/Power LED
A System Heartbeat/Power LED (LEDL)
is located below the BMC Heartbeat
LED on I/O back panel. When LEDL
is blinking, your system and its power
supply are working properly. See the
table on the right for more information.
SAS HDD LED
The LED indicator for the SAS HDD is lo-
cated at HDD LED2 on the motherboard.
When this LED is blinking, the SAS HDD
supported by the LSI SAS controller is
active. See the table at right for more
information.
SAS Overheat LED
A SAS Overheat LED is located at
LEDSOV1 on the motherboard. When
this LED is on, SAS overheating has
occurred.

5-10 Serial ATA Ports

Serial ATA Ports
An onboard SATA port is located next to the USB3 port on the serverboard to
provide serial-link signal transmission.
Note: For more information on SATA HostRAID configuration, please refer to the
Intel SATA HostRAID User's Guide posted on our website at www.supermicro.com.
Chapter 5: Advanced Serverboard Setup
System Heartbeat/Power
LED Status
State Definition
Green: Blinking System/PWR: Normal
SAS HDD Activity LED
LED Status
Color/State Definition
Green: Blinking SAS HDD:
Active
SAS Overheat LED
LED Status
Color/State Definition
Red: On SAS Overheating
5-17