Supermicro 6038R-DE2CR16L User Manual page 53

S S S
UPER TORAGE YSTEM 6038R-DE2CR16L User's Manual
Restore NVDIMMs
Select Enabled for the BIOS to restore onboard NVDIMM memory support
automatically to enhance memory performance. The options are Disabled
and Enabled.
Interleave NVDIMMs
Select Enabled to configure onboard NVDIMM modules for interleaving
support to enhance memory performance. The options are Disabled and
Enabled.
Global Reset
Select Enabled to trigger a global reset instead of the normal reset to allow
ADR to save NVDIMM settings. The options are Disabled and Enabled.
DRAM RAPL (Running Average Power Limit) Baseline
Use this feature to set the run-time power-limit baseline for DRAM modules. The
options are Disable, DRAM RAPL Mode 0, and DRAM RAPL Mode 1.
Set Throttling Mode
Throttling improves CPU reliability and reduces power consumption via automat-
ic-voltage control during CPU idle states. The options are Disabled and CLTT
(Closed Loop Thermal Throttling).
Socket Interleave Below 4GB
Select Enable for the memory above the 4G Address space to be split between
two sockets. The options are Enable and Disable.
A7 Mode
Select Enable for A7 (Addressing) mode support to improve memory perfor-
mance. The options are Enable and Disable.
DIMM Information
This item displays the status of a DIMM module as detected by the AMI
BIOS.
•
P1-DIMMA1 - P1-DIMMD1
•
P2-DIMME1 - P2-DIMMH1
7-14
Memory RAS (Reliability_Availability_Serviceability) Configuration
Use this submenu to configure the following Memory RAS settings.
RAS Mode
When Disable is selected, RAS is not supported. When Mirror is selected, the
motherboard maintains two identical copies of all data in memory for data backup.
When Lockstep is selected, the motherboard uses two areas of memory to run
the same set of operations in parallel to boost performance. The options are
Disable, Mirror, and Lockstep Mode.
Memory Rank Sparing
Select Enable to enable memory-sparing support for memory ranks to improve
memory performance. The options are Disabled and Enabled.
Patrol Scrub
Patrol Scrubbing is a process that allows the CPU to correct correctable memory
errors detected on a memory module and send the correction to the requestor
(the original source). When this item is set to Enable, the IO hub will read and
write back one cache line every 16K cycles, if there is no delay caused by internal
processing. By using this method, roughly 64 GB of memory behind the IO hub
will be scrubbed every day. The options are Enable and Disable.
Patrol Scrub Interval
This feature allows you to decide how many hours the system should wait before
the next complete patrol scrub is performed. Use the keyboard to enter a value
from 0-24. The Default setting is 24.
Demand Scrub
Demand Scrubbing is a process that allows the CPU to correct correctable
memory errors found on a memory module. When the CPU or I/O issues a
demand-read command, and the read data from memory turns out to be a
correctable error, the error is corrected and sent to the requestor (the original
source). Memory is updated as well. Select Enable to use Demand Scrubbing
for ECC memory correction. The options are Enable and Disable.
Device Tagging
Select Enable to support device tagging. The options are Disable and Enable.
7-15
Chapter 7: BIOS