Advanced - Technicolor TC7200.20 User Manual

4. Advanced

This page allows you to configure some advanced settings. The factory default values should provide good
results in most cases. We don't recommend you change these settings unless you have technical knowledge
of 802.11 wireless technology.
For expert users, details of all settings on this web page are provided below.

54 Mode: Except Auto mode, there are three modes for you choose, please check the specification of
TM
your wireless card and choose a proper setting.

Xpress Technology: When Xpress is turned on, aggregate throughput (the sum of the individual
TM
throughput speeds of each client on the network) can improve by up to 27% in 802.11g-only networks,
and up to 75% in mixed networks comprised of 802.11g and 802.11b standard equipment.

802.11n Protection: This method provides 802.11g and 802.11b devices can co-exist in the same
network without "speaking" at the same time. Default is "Auto".

Basic Rate Set: The rates that for all clients want to associate with. Choose "Default" or "All" for the
802.11 b/g/n.

Multicast Rate: The baseline levels that wireless device able to deliver in order to connect to the
wireless voice gateway. Lower multicast rates mean weaker, farther signals are allowed to connection.
Higher multicast rates mean that only close, strong signals are allowed.

NPHY Rate: Set the Physical Layer rate. The rate always set "Use Legacy Rate".
Fig. 2-37 Gateway\Wireless\Advanced
Page 62 / 85