Hitachi G1000 User Manual page 94

Procedure
1 Change the attribute of port (CL3-A) on the primary storage system to
.
Initiator.
raidcom modify port -port CL3-A -port_attribute MCU -IH0
2 Change the attribute of port (CL4-A) on the primary storage system to
.
RCU Target.
raidcom modify port -port CL4-A -port_attribute RCU -IH0
3 Change the attribute of port (CL3-C) on the secondary storage system to
.
RCU Target.
raidcom modify port -port CL3-C -port_attribute RCU -IH1
4 Change the attribute of port (CL4-C) on the secondary storage system to
.
Initiator.
raidcom modify port -port CL4-C -port_attribute MCU -IH1
Use the same procedure to change the port attributes for the alternate paths.
The alternate paths are not shown in the illustration.
Check command and output examples
1 Display the port information for the primary system.
.
4-14
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
Configuration and pair management using CCI