Prerequisites for global-active device setup using HCS
Before performing global-active device setup tasks using HCS, ensure the
following prerequisites are met:
•
The Virtual Storage Platform G1000 microcode version for both the
primary and secondary storage systems must be 80-02-01-XX/XX or later
to create global-active device pairs where the P-VOLs already have a
virtual LDEV ID assigned and are managed by user-defined virtual storage
machines, as with Nondisruptive Migration. This requirement is not
necessary for global-active device pairs created by adding secondary
storage resources to the primary storage default virtual storage machine.
•
Global-active device has been licensed (which includes Replication
Manager).
•
Replication Manager is installed and linked to HCS.
•
A pair management server is installed with Device Manager Agent and
Command Control Interface (CCI) at the primary and secondary storage
sites.
•
The external port of the primary and secondary storage systems are
connected to the external (quorum) storage system by Fibre Channel or
Fibre Channel over Ethernet.
•
You have registered (discovered) the primary, secondary, and external
storage systems using HCS.
Related topics
•
About global-active device setup on page 5-2
Select primary and secondary storage systems
Select primary and secondary storage systems listed by the global-active
device setup. Only valid storage systems with the correct firmware revision
are listed.
Procedure
1
Open the global-active device setup window:
.
¢
¢
2
On the Set up Global-Active Device window, click Select Storage
.
Systems.
3
From the Select Storage Systems window, select the primary storage
.
system from the list of available storage systems.
4
Select the secondary storage system from the list of available storage
.
systems.
5-4
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
From the Actions menu, select Set up Global-Active Device.
On the Replication tab, General Tasks, select Set up Global-
Active Device.
Using Hitachi Command Suite to set up global-active device