Assembly And Adjustments - Hitachi C 10FL Instruction Manual And Safety Instructions

English

ASSEMBLY AND ADJUSTMENTS

ESTIMATED ASSEMBLY TIME 50~70 MINUTES (2
PEOPLE)
ASSEMBLE STAND (FIG. A)
1. Unpack all parts and group by type and size. Refer
to parts list for quantities on page 29.
2. Attach one support (5) to leg (1) using three square
neck bolts (2) and three nuts (3).
NOTE:
•
Do not tighten bolts until stand is properly aligned
(see step # 8 before tightening).
• Position all supports to the INSIDE of the leg
assembles.
3. Attach other end of support to another leg using three
square neck bolts and three nuts. This completes the
front frame section.
4. Join rear frame assemblies using upper support
bracket (6), bottom support bracket (7), square neck
bolts and nuts.
5. Join front and rear frame assemblies using supports
(4), square neck bolts and nuts.
6. Place three foot pads (8) onto three leg and the
adjustable foot (9) and nut (10) onto the other leg.
7. Attach two hooks (11) using two screws (12) and
power cord storage (13) using two screws (14) to
the frame as desired. The hooks are used to hold the
fence.
8. Place stand on level surface and adjust so all legs
are contacting the floor and are at similar angles
to the floor and detents (19) in stand leg align with
supports, then tighten all bolts.
NOTE:
• Align the dust chute mounting hole and the stand
mounting hole before all bolts are tightened.
(Fig. B)
•
Stand should not rock after all bolts are tightened.
9. Mounting a caster (15) on each leg by tightening
three bolts (16) and nuts (17). Four casters.
NOTE: Two casters marked "A" are used for the
Front-Right & Rear-Left legs, two casters marked "B"
are used for the Front-Left & Rear-Right legs.
Fig. A
4
2
19
3
1
5
Front Side Frame
Assembly
14
13
6
18
7
10
9
4
11
12
16
17
8
ASSEMBLE TABLE SAW TO STAND (FIG. A, B)
1. Place protective corrugated cardboard or old blanket
on floor to protect the saw table surface.
2. Place the saw up-side down on the protective
material (Fig. B).
3. Position the recessed-side dust chute (1) and the
stand (2) up-side down on the saw base (3).
NOTE: Make sure front of stand and front of saw are
facing the same direction.
4. Line up four holes in saw base, dust chute and stand.
5. Fasten saw to dust chute and stand using four bolts
(18). (Fig. A)
6. Tighten all four bolts.
7. Carefully set the saw in its upright position on a clean
level surface.
8. Push down on the lever of right wheel assemblies
(15-Fig. A) to unlock. Push up on the lever of right
wheel assemblies to lock.
NOTE:
• You will need assistance from another person.
• Casters not shown for clarity of view.
Fig. B
Stand
mounting hole
Dust chute
mounting hole
Saw base hole
15
– 12 –
2
1
3