Audiovox PRO-9056 Installation Manual page 3

To exit program mode, turn ignition off, or press and release valet switch.
RF Programmable Features Bank 3 Is Remote Start Selectable Features:
Feature Selection 1 Chirp
1st Defrost Output Not Available
2nd RF Start Chirp Not Available
3rd Run Time 5 Mins
4th Parking Lights On Steady
5th Input Check Voltage
6th Voltage Level >0.5V B4 Start
7th Ign. 2 Select Off During Crank
8th Ign. 3 Select Not Available
9th Diagnostics Off
10th Crank Time 0.8 Sec
11th Gas/Diesel Gas
12th Transponder O/P While R/S On
13th Temp Start Not Available
14th Crank Averaging Averaging
15th R/S Shock Not Available
16th Turbo Select Not Available
17th Black/Blue (Aux O/P) Single Pulse
Note: When setting feature #17 to operate as feature #1 Bank 1 the transmitter will also control this output only while running under R/S command. So in
other words, if this output is used to unlock the doors with the transmitter, the doors will unlock on startup. To relock the doors, use the After Start Black
Green wire of the 4 pin connector.
When using the RF programmer, enter the program mode as follows:
Turn the ignition on
Press and release valet switch 3 times
turn ignition off then on
Press and hold valet switch for 5 seconds
Siren chirps 2 times indicating access to RF feature program mode.
To exit program mode, turn ignition off, or press and release valet switch.
2 Chirps 3 Chirps 4 Chirps
10 Mins 15 Mins 20 Mins
Flashing
Tach DBI Input
< 0.5V B4 Start
On During Crank Same As Accy.
On
1.0 Sec 1.5 Sec 2.0 Sec
Diesel 10 Diesel 15 Diesel 20
During Start Until Ign. Off
Preset Time Note: When averaging, the engine must be started 4 times with the key to be effective.
As Feature #1Bank 2
5 Chirps 6 Chirps