Table of Contents
Advertisement
Installation
DANGER
Laser radiation!
During installation follow the instructions specified in section "Laser safety" on page 4.
DANGER
When using additional components!
Additional components can cause dangerous laser beam diffusion when they are not
properly connected.
Notice
Safety switch required!
We strongly recommend to install a remote manual safety switch to the device. The safety switch turns the
laser off immediately.
Safety switch
We strongly recommend to connect a remote safety switch as shown in the following figure to connector (7) of
the device. An adapter for safety switches equipped with phone jacks is included in the delivery
If you press the switch, the laser beam will be turned off immediately. To release the switch and to start the
operation again, turn the knob clockwise.
General installation rules
You can install the device on the wall, the ceiling or on the ground. A mounting bracket is provided together
with the device.
WARNING
Injuries caused by falling parts!
Make sure that the installation complies with the standards and rules that apply in your
country.
Always secure the device with a secondary safety attachment, such as a safety cable or a
safety chain.
Notice
Malfunction or damage to equipment!
The distance between light output and the illuminated surface must be more than 0.5 m (19.7 in).
Ensure also that there is enough room for ventilation.
The ambient temperature must always be between 10 °C (50 °F) and 40 °C (104 °F).
www.thomann.de
5
Advertisement
Table of Contents
