Section 4 - Installation; Installing Welding Generator (See Section 4-3); Installing Exhaust Pipe - Red-D-Arc D502K 5+4 Technical Manual

4-1. Installing Welding Generator (See Section 4-3)

Movement
OR
Grounding
2

4-2. Installing Exhaust Pipe

Tools Needed:
1/2 in
TM-4412 Page 8
SECTION 4 – INSTALLATION
Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
1
OR
Electrically bond generator frame to
vehicle frame by metal-to-metal
contact.
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
3
4
GND/PE
2
install2 1/01– Ref. ST-800 652 / Ref. ST-800 477-A / ST-158 936-A / S-0854
Location
OR
Y Always securely fasten weld-
ing generator onto transport
vehicle or trailer and comply
with all DOT and other appli-
cable codes.
Y Always
ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
1 Generator Base
2 Metal Vehicle Frame
3 Equipment Grounding Terminal
4 Grounding Cable
Use #10 AWG or larger insulated
copper wire.
Y If unit does not have GFCI re-
ceptacles, use GFCI-pro-
tected extension cord.
Y Stop engine and let cool.
.
Point exhaust pipe in desired di-
rection but always away from
front panel and direction of travel.
803 122 / Ref. 802 169 / Ref. 202 705
D502K 5+4