Installing Welding Generator; Section 4 – Installation - Red-D-Arc D502K 5+2 Owner's Manual

-1. Installing Welding Generator

Movement
Location
1
Grounding
GND/PE
Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
OM-4412 Page 14
SECTION 4 – INSTALLATION
OR
OR
2
Electrically bond generator frame to
vehicle frame by metal-to-metal contact.
Y Bed liners, shipping skids, an some running
gear insulate the welding generator from the ve-
3
hicle frame. Always connect a ground wire from
the generator equipment grounding terminal to
bare metal on the vehicle frame as shown.
18 in
(460 mm)
OR
18 in
(460 mm)
18 in
(460 mm)
Y Always securely fasten weld-
ing generator onto transport
vehicle or trailer and comply
with all DOT and other applica-
ble codes.
Y Always
ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
Y If unit does not have GFCI re-
ceptacles, use GFCI-protected
extension cord.
.
See Section 4-2 for mounting in-
formation.
Grounding:
1 Equipment Grounding Terminal
(On Front Panel)
2 Grounding Cable (Not Supplied)
3 Metal Vehicle Frame
Connect cable from equipment
ground terminal to metal vehicle
frame. Use #10 AWG or larger insu-
lated copper wire.
install3 11/02 – Ref. 800 652 / Ref. 800 477-A / 803 274