Servicing Fuel And Lubrication Systems - Red-D-Arc D502K 5+4 Technical Manual

Cc/cv dc diesel welder
Table of Contents

Advertisement

7-6. Servicing Fuel And Lubrication Systems

Tools Needed:
5
3
Right Side
Y Stop engine and let cool.
Y After servicing, start engine and
check for fuel leaks. Stop engine,
tighten connections as necessary,
and wipe up spilled fuel.
1
Oil Filter
2
Oil Drain Valve And Hose
3
Oil Fill Cap
4
Primary Fuel Filter (In-Line)
5
Secondary Fuel Filter
6
Fuel Tank Sludge Drain Valve
To change oil and filter:
Route oil drain hose and valve through hole
in base. See engine manual and engine
maintenance label for oil/filter change in-
formation.
D502K 5+4
1
To drain water from fuel system:
Open primary fuel filter petcock and drain
water into metal container. Close petcock
when water-free fuel flows.
To replace primary fuel filter:
Turn filter counterclockwise. Remove filter.
Apply thin coat of fuel to gasket on new filter.
Fill filter with fuel. Install filter and turn clock-
wise. Bleed air from fuel system according
to engine manual.
Inspect fuel line, and replace if cracked or
worn.
To replace secondary fuel filter:
See engine manual.
Close doors.
2
6
Ref. 800 159-E / Ref. 802 170 / 803 123-A
To drain sludge from fuel tank:
Y Beware of fire. Do not smoke and
keep sparks and flames away from
drained fuel. Dispose of drained fuel
in an environmentally-safe manner.
Do not leave unit unattended while
draining fuel tank.
Y Properly lift unit and secure in a level
position. Use adequate blocks or
stands to support unit while drain-
ing fuel tank.
Attach 1/2 ID hose to drain valve. Put metal
container under drain, and use screwdriver
to open sludge drain valve. Close valve
when sludge has drained. Remove hose.
4
TM-4412 Page 27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents