Connecting To Weld Output Terminals - Red-D-Arc D502K 5+4 Technical Manual

4-7. Connecting To Weld Output Terminals

1
Y Stop engine.
1 Positive (+) Weld Output Terminal
2 Negative (–) Weld Output Terminal
For Stick and TIG welding Direct Current
Electrode Positive (DCEP), connect elec-
trode holder cable to Positive (+) terminal on
left and work cable to Negative (–) terminal
on right.
For Direct Current Electrode Negative
TM-4412 Page 12
Tools Needed:
3/4 in
2
(DCEN), reverse cable connections.
If equipped with optional polarity switch,
connect electrode holder cable to Electrode
terminal on left and work cable to Work ter-
minal on right.
For MIG and FCAW welding Direct Current
Electrode Positive (DCEP) on CC/CV mod-
els, connect wire feeder cable to Positive
(+) terminal on left and work cable to Nega-
tive (–) terminal on right. Use Process/Con-
tactor Control switch to select type of weld
output (see Section 5-3).
For Direct Current Electrode Negative
(DCEN), reverse cable connections.
If equipped with optional polarity switch,
connect wire feeder cable to Electrode ter-
minal on left and work cable to Work termi-
nal on right.
803 122
D502K 5+4