I Installing the Fax Board (if the printer controller is mounted)
4048U006AB
➁
➀
4398IXE015DA
4398IXC004DA
4398IXC010DA
1. Remove the Rear Cover. (nine screws)
2. Using nippers, break the knockout
Left Side Cover.
NOTE
If the NC-502 is to be mounted at the same
➀
time, break both knockouts
3. Disconnect hookup harness of the Image
Controller Board.
4. Remove the Image Controller Board.
(four screws)
FK-505
4398IXC011DA
➀
of the
➁
and
.
4398IXC012DA
4398IXC013DA
– 4 –
5. Change the position of the jumper (CJ1) on
the Control Board (from 1, 2 to 3, 4).
6. Connect the Fax Board to the hookup
connector of the Control Board.
7. Secure the Fax Board in position using the
four Screws furnished with the kit.