Fieldmann FZR 3004-B Manual page 9

Putting into operation
EN 10
Mulching
Installation and removal of the accessories must always be take place with switched off engine.
Please make sure the stability of the attached mulching accessories after installing.
For mulching plate, you only allowed use the accessories from original factory
Always avoid to clear away an excessive quantity grass so that the mower mechanism and the engine are
overloaded.
Reducing the speed of self-propelled will help you to pass excessive grass.
Assembly of accessories
Put the baffle plate and raises, aim at the round hole underside, fax up the auto locking hook engage.
Disassembly of accessories
Press the tightly by thumb in the center, then loose and deflect direction take down the mulching plate.
Hang up the grass catcher
Raise the baffle plate and hang up the grass catcher in the illustration shown.
DRIVE CONTROL (see pic. 2)
Self-propelling is controlled by holding the operator presence control bar down to the handle and pushing the
drive control lever forward until it clicks; then releasing the lever.
Forward motion will stop when the operator presence control bar is released. To stop forward motion without
stopping engine, release the operator presence control bar slightly until the drive control disengages. Hold
operator presence control bar down against handle to continue mowing without self-propelling.
ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels for deepcut, adjust cutting height to suit your requirements. Medium
position is best for most lawns.
BEFORE STARTING ENGINE ADD OIL
Your lawnmower is shipped without oil in the engine.
Before each subsequent use the oil level must be check and if necessary topped up with500ml SAE30
For type and grade of oil to use, see „ENGINE" in the Maintenance section of this manual.
ATTENTION: Do not overfill engine with oil, or it will smoke heavily from the muffler on startup.
1. Be sure lawnmower is level.
2. Remove oil dipstick from oil fill spout.
3. Insert and tighten dipstick.
4. Check oil level before each use. Add oil if needed.
5. Fill to full line on dipstick.
6. Change the oil after every 25 hours of operation or each season.
7. You may need to change the oil more often under dusty, dirty conditions. See „TO CHANGE ENGINE OIL" in the
Maintenance section of this manual.
Note: Check oil level before each use.
(15W-40) engine oil
FZR 3004-B/FZR 3007 BS