Table of Contents
Advertisement
Maintenance and storage
EN
16
CHANGING BLADES (see pic. 6)
To replace the blade, undo the screw. Empty the oil tank before removing the blade.
Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade
screw should also be replaced.
Changing the Oil (see pic 8)
The oil drain plug is located under engine.
Have a container ready to catch the oil and remove the drain plug.
Once the oil has been emptied, replace the drain plug making sure that the washer is in place and wipe clean
any spillages.
Refill with SAE30 oil.
When the dipstick is rested on the filler pipe (l.e. not screwed in place), the oil lever must be between the Min.
and Max. marks on the dipstick. Do not overfill.
Start the engine and allow it to run briefly.
Stop the engine, wait one minute and check the oil level. Top up if necessary.
SPARK PLUG (see pic. 9)
Once the engine has cooled, remove the spark plug using the box spanner supplied; clean the plug with a wire
brush. Using a feeler gauge, set the gap to 0.75 mm (0.030"). Refit the spark plug taking care not to over tighten.
AIR FILTER (see pic. 11)
Unclip the air filter cover and remove the sponge filter element. To avoid objects falling into the air intake, replace
the air filter cover.
DRAINING THE FUEL TANK AND CARBURETOR (see pic. 10)
1. Place an approved gasoline container below the carburetor, and use a funnel to avoid spilling fuel.
2. Remove the drain bolt, and then move the fuel valve lever to the ON position
3. After all the fuel has drained into the container; reinstall the drain bolt and washer. Tighten the drain bolt
securely.
STORAGE
The same petrol must not remain in the tank for more than one month. Thoroughly clean the mower and store it
indoors in a dry place.
THE ENVIRONMENT
In order to protect the environment, we recommend that the following points should be given special considera-
tion:
Always use pure unleaded petrol.
Always use a funnel and/or petrol can with a level control to avoid spillage when refilling the fuel tank.
Do not fill the fuel tank completely.
Do not overfill with engine oil.
When changing the oil, ensure that all the used oil is collected. Avoid spillage. Take the used oil to a recycling unit.
Do not dispose of used oil filter in a rubbish bin. Take it to a recycling unit.
Replace the silencer if faulty. When carrying out repairs, always use original spare parts.
Always seek professional help when the carburetor requires adjustment.
FZR 3004-B/FZR 3007 BS
Advertisement
Table of Contents
