Messages - Panasonic VDR VDR-D220 Operating Instructions Manual

Others

Messages

CANNOT READ THIS DISC.
PLEASE CHECK FOR
SCRATCHES OR STAINS
ON DISC.
NO DATA.
THIS DISC IS
INCOMPATIBLE.
PLEASE CHECK THE
DISC.
RECOMMENDED TO USE
PANASONIC DISC
CANNOT RECORD.
(THIS DISC IS FINALIZED)
CANNOT RECORD. DISC
IS FULL.
CANNOT RECORD. THE
NUMBER OF SCENES HAS
EXCEEDED THE MAXIMUM
LIMIT.
CANNOT OPERATE.
TEMPERATURE IS HIGH.
PLEASE TURN OFF AND
WAIT A WHILE.
FINALIZE THE DISC TO
ENABLE PLAYBACK ON
OTHER DEVICES.
CANNOT UN-FINALIZE
THIS DISC.
CHECK CARD.
CARD LOCKED.
96
LSQT1146
The disc is scratched or dirty. Eject the disc and clean it. (l 24) If
there are scratches on the disc, use a new disc.
There are no images recorded on the disc or card.
You inserted an incompatible disc (copy-protected discs, etc.).
You inserted a disc that cannot be read on this unit (a disc recorded
in an incompatible data format etc.).
You inserted a disc that does not meet the DVD standard for quality
and performance so you may not be able to record normally. Refer
to the following support site for information about discs that have
been confirmed as compatible by Panasonic.
http://panasonic.co.jp/pavc/global/cs/e_cam
(This website is in English only.)
A finalized DVD-RW (Video format) or DVD-R has been inserted.
After finalizing, the discs become play-only and cannot record. If you
un-finalize a DVD-RW (Video format), it can be used for recording.
(l 75)
The disc is full or the number of scenes has reached the maximum
limit so no further data can be recorded. Delete unnecessary scenes
(l 64) or insert a new disc.
The temperature of the unit is high so it cannot be operated. Turn off
the power, wait until the unit cools and then turn on the power again.
If you insert a DVD-RW or a DVD-R disc recorded in this unit (that
has not been finalized) into another device such as DVD recorder,
computer, etc., the disc may become unusable. Be sure to finalize
the disc on this unit before inserting it in other devices.
DVD-R cannot be un-finalized.
This card is not compatible or it cannot be recognized by the unit.
The write protection switch on the SD card is set to LOCK. (l 23)