Advertisement
NOTE:
INST
ALLA
TION
INST
ALLA
TION
retightened where necessary, before and after
installation.
1.
MOUNTING OPTIONS
A
DOWNROD MOUNT
- Use a square-head screwdriver loosen the two upper jam screws on the yoke.
- Position downrod inside canopy.
- Route wires exiting yoke on motor through ceiling canopy and downrod.
- Position downrod/canopy into yoke and align holes in yoke and downrod.
- Insert bolt through hole in yoke and downrod. Be careful not to damage
or cut the fan wires.
-
Install the flat washer to the bolt.
end of the bolt.
- Secure downrod in position by tightening upper jam screws.
Upper jam
screw
Bolt
Fig. 2a
B
FLUSH MOUNT
- Optional for some models.
- Remove rubber ring from canopy (see Fig. 2d).
- Remove the upper motor housing screws.
- Position canopy over corresponding holes on motor and secure with the
upper motor housing screws, ensuring the rubber bushing is placed between
the canopy and the motor.
Canopy
Rubber
ring
Fig. 2d
All set screws must be checked and
Secure with cotter pin through hole in the
CAUTION
Flat washer
Yoke
Upper jam
screw
Cotter
pin
Fig. 2b
Do not loosen two lower jam screws
Upper motor
housing screws
& lock washers
Canopy
Rubber bushing
Motor
Fig. 2e
4
8.
LIGHT KITS
- Remove light kit screws and washers.
- Connect polarized connectors of light kit to corresponding connectors
found in switch housing.
WARNING: BE SURE TO TURN OFF POWER BEFORE INSTALLING.
- Carefully tuck electrical wires back into switch housing, align light kit with
switch housing and secure with three light kit screws and washers.
- Install proper wattage and type of bulb identified on light housing or shade.
- Place glass on light housing and secure
Yoke
Fig. 2c
NOTE:
Electrical diagrams are for reference only. Light kits that are not packed with
the fan must be CSA/UL listed and marked suitable for use with the model
fan you are installing. Switches must be CSA/UL general use switches.
Refer to the instructions packaged with the light kits and switches for proper
assembly.
WARNING: Ensure that all connections, set screws and screws are securely
tightened before the next step.
(See Fig. 10a, Fig.10b).
Fig. 10a
Red or Blue
Wires
White wire
Black or Blue
White wire
Wires
Light kit
screws
Fig. 10b
Steel
washer
Rubber
washer
Glass
Fibre washer
Nut
Decorative
cover
Finial
9
Advertisement
