Advertisement
3.
ELECTRICAL HOOK-UP
A
CONNECTING THE (GREEN) GROUND WIRE
DOWNROD MOUNT
Marrette
- Connect ground wire from outlet box
to green wire from mounting bracket
and downrod using a marrette
Fig. 4
(not supplied).
NOTE: Once ground wires are connected, carefully tuck wires and marrette into the
outlet box making sure that the wires are clear of the hemisphere and
downrod when positioned in mounting bracket (downrod mount only).
FLUSH MOUNT
Marette
- Connect ground wire from outlet box
to green wire from mounting bracket
using a marrette (not supplied).
Fig. 5
6
3.
ELECTRICAL HOOK-UP (Continued)
B
CONNECTING BLACK, WHITE, AND (RED OR BLUE) WIRES
White Wire
Black Wire
Red or Blue
Fig.6
Wire
NOTE: Once wires are connected, carefully tuck wires and marrettes into the
outlet box making sure that the wires are clear of the hemisphere
and downrod when positioned in mounting bracket
(downrod mount only).
4.
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to (B) screws then
turn to lock.
- Position and tighten the two screws and washers (A) then tighten the two
screws (B).
ENGAGE HEMISPHERE (Downrod Mount Only)
5.
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
(A)
Washers
(B)
(A)
Fig.7a
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
- Connect white wire from outlet box to white
wire from fan using marrette (no t supplied).
- Connect black wire from outlet box to black
wire from fan plus (red or blue wire) using
a marrette.
NOTE: A red or blue wire would be power
for a light kit if applicable.
(B)
Groove
Hemisphere
Downrod
Fig.7b
7
Advertisement
