Power Supply; Charging Time And Available Recording Time - Panasonic NV-EX21EG Operating Instructions Manual

2
POWER CHARGE
QUICK 100%
1
3
A
B
CGA-D07SE*
1 h 05 min. (55 min.)
C
35 min. (30 min.)
A
CGR-D08S
B
1 h 15 min. (1 h 05 min.)
CGR-D120
C
40 min. (35 min.)
A
CGP-D14S
B
2 h 10 min. (1 h 45 min.)
CGP-D210
C
1 h 05 min. (55 min.)
A
CGR-D16S
B
2 h 30 min. (2 h 05 min.)
CGR-D220
C
1 h 15 min. (1 h 05 min.)
A
CGR-D53S
B
8 h 15 min. (6 h 45 min.)
CGR-D815
C
4 h 10 min. (3h 25 min.)
10

Power Supply

ª Using the AC Adaptor
1
2
1
ª Using the Battery
Before use, fully charge the Battery.
1 1 1 1
2 2 2 2
To Remove the Battery
Set the [OFF/ON/MODE] Switch
Lever to the right
≥When attaching or removing battery, set [OFF/ON/MODE] Switch to
[OFF] and make sure the Operation Mode Lamp is not lit.
ª Supplying Power from the Cigarette Lighter Socket in a
Car
The use of the Car Adaptor Cord (VW-KA7E; optional) together with the AC
OFF ON MODE
CAMERA
Adaptor makes it possible to supply power to the Movie Camera in a car for
VCR
CARD P. B
recording and playback. It also allows charging the Movie Camera's Battery.
2
≥After use, be sure to disconnect the Car Adaptor Cord from the Cigarette
Lighter Socket.
≥Be sure to start the car engine before you connect the Car Adaptor Cord,
otherwise the fuse may blow.
≥For other notes concerning this item, see page 46.
~~~~~~~~~~~~~~~~~~~~~~~~

Charging Time and Available Recording Time

A
B
NV-EX21
C
1 h.
(Intermittent Recording Time is the available recording time with repeated
recording and stopping actions.)
≥"1h30min." indicates 1 hour and
1 h 50 min.
≥Battery CGA-D07SE* is supplied.
≥The times shown in the table are approximate times. The numbers in
parentheses indicate the recording time when the LCD Monitor is used. In
actual use, the available recording time may be shorter.
2 h.
≥The times shown in the table are for continuous recording at a temperature
of 20oC and humidity of 60%. If the Battery is charged at a higher or lower
temperature, the charging time may be longer.
3 h 15 min.
5 h 20 min.
Insert the battery-shaped connector of the DC Input Lead
into the Battery Holder on the Movie Camera and slide it
toward the front until it locks with a click.
Connect the AC Mains Lead to the AC Adaptor and the AC
mains socket.
≥The AC Mains Lead's output plug cannot be pushed fully into the AC
Adaptor socket. A gap will remain as shown
≥Before connecting or disconnecting the power supply, set the
[OFF/ON/MODE] Switch on the Movie Camera to [OFF] and make
sure that the Operation Mode Lamps go off.
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input Lead is
connected to the AC Adaptor, disconnect them.
≥After the [POWER] Lamp has lighted, the [CHARGE] Lamp flashes.
1
When the [100%] Lamp
Attach the charged Battery to the Movie Camera.
3
, and then slide the Battery to remove it.
Charging Time
Maximum Continuous Recording Time
Intermittent Recording Time
1
.
on the AC Adaptor is lit, charging is finished.
2
to [OFF], and the [BATTERY
30 minutes.
EJECT]