Attaching The Lens Cap; Adjusting The Grip Belt; Inserting A Cassette - Panasonic NV-EX21EG Operating Instructions Manual

1
3
1
2
1
OPEN/EJECT
1
R E C
SAVE

Attaching the Lens Cap

2
To protect the Lens surface, attach the Lens Cap.
1
Pass the loop of the Lens Cap Cord through the Lens Cap
Installation Hole on the Movie Camera.
2
Pass the opposite side of the Lens
cord's hoop.
3
Pull the Lens
4
Attach the Lens Cap.
≥The removed Lens Cap can be hooked onto the Grip Belt
are not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
4
≥If the supplied Lens Hood for MEGA Still Picture Recording is attached,
Lens Cap
1

Adjusting the Grip Belt

Adjust the length of the Grip Belt to the size of your hand.
1
Pass your hand through the Grip Belt and adjust its length.
2
Fold back the end of the Grip Belt to securely fasten the
velcro tape closure.
≥The Grip Belt can also be adjusted in SD Camera Style.
~~~~~~~~~~~~~~~~~~~~~~~~~

Inserting a Cassette

When power is supplied to the Movie Camera, the Cassette can be taken out
without turning the Movie Camera on.
1
Slide the [OPEN/EJECT] Lever to open the Cassette
2
Compartment Cover.
2
Insert a Cassette.
3
Close the Cassette Compartment Covers to lock the Cover.
ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure prevention slider (by sliding it in the
[REC] arrow direction).
3
≥For other notes concerning this item, see page 46.
Cap to the direction of the arrow.
cannot be attached.
Cap Cord through the
1
. (When you
the
1
on the cassette (by
11